Canon imagePRESS C1 Service Manual - page 179
Manual is about: imagePRESS C1 Series
of
1265
Chapter 2
2-85
- 2 screw [3]
F-2-311
8) After removing the filter [1], remove the sub station upper rear [2]/rear up-
per [3] face covers.
- 7 screws [4]
F-2-312
9) Remove the fan duct [1]. (The fan duct detached is not used.)
- 2 screws [2]
F-2-313
10) Disconnect the short connector [1].
F-2-314
11) Connect the lattice cable [1].
- 2 screws (binding; M3X6) [2]
F-2-315
12) Free the harness [2] from the wire saddle [1] at the connector side only.
F-2-316
13) Secure the 2 harnesses [1] with the edge saddle [2].
F-2-317
14) Connect the 2 connectors [1].
[3]
[1]
[2]
[3]
[4]
[2]
[4]
[4]
[4]
[3]
[4]
[1]
[1]
[2]
[1]
[1]
[2]
[1]
[2]
[2]
[1]