Canon imagePRESS C1 Service Manual - page 1028
Chapter 16
16-131
16.5.1.2 COPIER List
0012-8333
imagePRESS C1 P
1. INSTALL
CHK-TYPE
Specify a partition number to execute HD-CHECK.
Setting range (0 to 65535)
0: Sector checking and recovery of the entire HDD
1: Image storage area
2: Versatile file saving area
3: PDL file saving area
4: Program file saving area
5: MEAP application
6: Aaddress book / Transfer settings
7: MEAP save data
8: System log storage area
Versatile file is data control information such as user setting data, various log data, PDL spool
data, and image data.
Operation method
1) Select this item.
2) Select a partition number using numeric keys.
3) Press the OK key.
1
HD-CHECK
Execute the partition check and recovery specified by CHK-TYPE.
Operation method
1) Select this item.
2) Press the OK key.
3) The result (1: OK, 2: NG (hardware), 3: NG (software), recovered sector / substitute sector) is
displayed.
1
HD-CLEAR
Initialize the partition specified by CHK-TYPE.
- When 0 or 4 is specified, this mode is invalid.
- When 1 is specified, the image control data saved in the SRAM area or versatile file saving area
is also initialized.
Operation method
1) Select this item.
2) Press the OK key.
When 1 or 3 is selected in CHK-TYPE and
after the power is turned OFF/ON.
It takes approximately five minutes for initialization. During the initialization, the progress bar
advances slowly. Do not turn off the power during initialization.
1
DEBUG-1
Use it to set the type of log to store/timing of storage to the HDD.
settings
0 to 3 (default: 0)
- Do not use for servicing (For the analysis of the cause of trouble)
- Obey the instruction by the quality support section for usage.
2
DEBUG-2
Use it to print out logs stored on the HDD.
1) Select the item.
2) Press the OK key.
3) See that the log is printed. (about 2 sheets of A4)
- Do not use for servicing (For the analysis of the cause of trouble)
- Obey the instruction by the quality support section for usage.
2
COPIER>FUNCTION>SYSTEM
Subheading Contents
Level