Canon imagePRESS C1 Service Manual - page 258
Chapter 4
4-10
T-4-8
- When XX = 01 - FF
XX
YY
Description
Remedy
00
01
HDD cannot be recognized. Boot
partition (BOOTDEV) not found
during startup.
1. Turn the Main Power Switch OFF and check the HDD cable connection. After confirmation, turn the Main
Power Switch ON.
2. After turning the Main Power Switch ON, check that the HDD spins up and that 5 V/12 V power is being
supplied.
3. If the above does not correct the problem, replace the HDD and reinstall the system. If this doesn't work,
replace the main board.
02
No system for main CPU
1. Start the system in Safe Mode (1+7), perform a full format using SST, reinstall the system (System, Lang,
RUI), and turn the Main Power Switch OFF and then ON again.
2. If the above does not correct the problem, the HDD may be assumed to be damaged, so replace the HDD
and reinstall the system.
03
Write Abort detected for Boot Device
1. Perform Write Abort Sector detect and repair.
1-1. Since Service Mode cannot be entered, perform the following procedure.
1-2. Turn the power OFF. Turn the power ON again while holding down the 1 and 9 keys. This will
automatically start the Write Abort Sector repair routine, causing the screen to go completely black.
1-3. Progress status will appear after a short time as this routine takes about 40 to 50 minutes to execute.
Execution is done when the screen goes completely white.
1-1. Set CHK-TYPE = 0, execute HD-CHECK (takes 40 to 50 minutes), and turn the Main Power Switch
OFF and then ON again.
2. If the above does not correct the problem, start up in Safe Mode, perform a full format using SST, reinstall
the system (System, Lang, RUI), and turn the Main Power Switch OFF and then ON again.
3. If the problem is still not corrected, the HDD may be assumed to be damaged, so replace the HDD and
reinstall the system.
06
No system for sub-CPU
1. Start the system in Safe Mode (1+7), perform a full format using SST, reinstall the system (System, Lang,
RUI), and turn the Main Power Switch OFF and then ON again.
2. If the above does not correct the problem, the HDD may be assumed to be damaged, so replace the HDD
and reinstall the system.
07
No ICCProfile
1. Start the system in Safe Mode (1+7), perform a full format using SST, reinstall the system (System, Lang,
RUI), and turn the Main Power Switch OFF and then ON again.
2. If the above does not correct the problem, the HDD may be assumed to be damaged, so replace the HDD
and reinstall the system.