Canon imagePRESS C1 Service Manual - page 331
Chapter 5
5-52
Points to Note When Attaching the Arm Unit
- Turn the arm unit in the direction shown by the arrow until the screw hole
[1] matches that of the control panel arm unit.
F-5-264
- Be sure to fit the screws in order. Adjust the position of the arm unit [1] by
the 1 screw [2], and then secure it in place by the 4 screws [3].
F-5-265
Points to Note when Fixing the Control Panel Interface Cable [1] in
Place
Of the 3 positions of wire saddle [2] to be secured in place, adjust the position
of the wire saddle on the rear side and the seal [3].
F-5-266
Points to Note when Attaching the Arm Cover 1
Be sure not to have the cable caught in.
F-5-267
Points to Note when Securing the Arm Cover 1 in Place
Be sure that the arm cover 1 and the arm cover 2 are not displaced.
F-5-268
[1]
[2]
[3]
[3]
[1]
[2]
[1]
[3]