Canon imagePRESS C1 Service Manual - page 153
Chapter 2
2-59
F-2-184
22) Tighten the screw (W sems; M4X12) [1] from the back of the control
panel.
F-2-185
23) Fix the ferrite core [1] to the control panel interface cable.
F-2-186
24) Fix the control panel interface cable [1] using the 2 edge saddles [2] and
the wire saddle [3], and plug the connector [4] into the socket of the con-
trol panel.
F-2-187
25) Attach the arm cover 4 [1] from behind the arm unit.
- 1 screw (Binding; M4X10) [2]
F-2-188
26) Attach the lock hinge cover R [1].
- 2 bosses [2]
- 2 screws (P tightening; M3X10) [3]
[1]
[1]
[1]
[1]
[2]
[3]
[4]
1, Make the ferrite core [1] in the position of the chart.
2, Be sure to adjust the cable length so that the cable [1] is located inside the
plate [2].
MEMO:
If the control panel tilts either to the left or right, perform the following
adjustment.
1) Loosen the 4 screws [1] on the back of the control panel.
2) Set the control panel [2] in a desirable position and tighten the screw.
[1]
[2]
[2]
[1]
[1]
[1]
[2]
[1]
[2]