Canon imagePRESS C1 Service Manual - page 133
Manual is about: imagePRESS C1 Series
of
1265
Chapter 2
2-39
F-2-78
5) Attach the balancing cylinder [1] to the developing rotary. Make sure that
the pin [2] at the Balancing Cylinder is found in the hole located at the
backside of the developing rotary [3].
F-2-79
6) Push the 2 developing assembly fixed arms [1] in the direction of [A], set
them in the direction of [B] to fix.
- 2 screws [2]
F-2-80
F-2-81
7) Repeat the step 3) to 6) to set the 2 balancing cylinders to the developing
rotary.
In the case of attaching the balancing cylinder, make sure not to bump into
the ATR sensor shutter [1].
[2]
[1]
[2]
[1]
[1]
[1]
[2]
[3]
[1]
[A]
[A]
[B]
[B]
[1]
[2]
[2]