Canon imagePRESS C1 Service Manual - page 321
Chapter 5
5-42
7) For the subsequent steps, see step 4 to 6 in 'Removing the Original Size
Sensor' (in the case of imagePRESS C1 Series).
5.4.13 Scanner Drive Cable
5.4.13.1 Preparation for Removing the Scanner Motor
Drive Wire (imagePRESS C1 Series/imagePRESS
C7000 Series)
0013-9970
imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+
1) Remove the decurler.
2) Detach the control panel.
3) Remove the copyboard glass. (page 5-16)Reference [Removing the
Copyboard Glass]
4) Remove the hopper unit.
5.4.13.2 Removing the Scanner Drive Wire (imagePRESS
C1 Series)
0013-9971
imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+
1) Detach the small cover (left front) [1] and the small cover (left rear) [2]
using a flat-blade screwdriver etc,.
F-5-205
2) Remove the 2 screws [1] on the back side of the arm unit.
F-5-206
3) Press the arm cover 1 [1] in the direction shown by the arrow to detach it
upward.
F-5-207
4) Remove the control panel interface cable [2] from the 3 wire saddle [1].
F-5-208
5) Remove the arm unit [1].
- 5 screws [2]
F-5-209
- Turn the arm unit in the direction shown by the arrow until the screw hole
[1] matches that of the control panel arm unit.
F-5-210
- When attaching the arm unit [1], determine the position with the 1 screw
[2] and then fix it with the 4 screws [3].
F-5-211
6) Detach the arm cover 3 [1].
- 2 screws [2]
[1]
[2]
[1]
[1]
[1]
[2]
[2]
[2]
[2]
[1]
[1]
[2]
[3]
[3]
[1]