Canon imagePRESS C1 Service Manual - page 988
Chapter 16
16-91
T-16-89
3. DENS
T-16-90
COPIER>ADJUST>IMG-REG
Subheading Contents
Level
REG-V-Y/K
Make a coarse adjustment of the Y/K color writing position in the sub scanning direction.
Adjustment method
- When you increase the value by 1, the pattern moves to the trail edge.
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
1
Adjustment range: -10 to 10 (Unit: 1 pixel)
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
Reference:
This mode is used to enter a factory adjustment value. Do not make an adjustment in the field.
REG2-V-Y/K
Make a coarse adjustment of the Y/K color writing position in the sub scanning direction. (the
second image of the two images aligned on ITB)
Adjustment method
- When you increase the value by 1, the pattern moves to the trail edge.
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
1
Adjustment range: -10 to 10 (Unit: 1 pixel)
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
Reference:
This mode is used to enter a factory adjustment value. Do not make an adjustment in the field.
REG-V-M
Make a coarse adjustment of the M color writing position in the sub scanning direction.
Adjustment method
- When you increase the value by 1, the pattern moves to the trail edge.
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
1
Adjustment range: -10 to 10 (Unit: 1 pixel)
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
Reference:
This mode is used to enter a factory adjustment value. Do not make an adjustment in the field.
REG2-V-M
Make a coarse adjustment of the M color writing position in the sub scanning direction. (the
second image of the two images aligned on ITB)
Adjustment method
- When you increase the value by 1, the pattern moves to the trail edge.
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
1
Adjustment range: -10 to 10 (Unit: 1 pixel)
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
Reference:
This mode is used to enter a factory adjustment value. Do not make an adjustment in the field.
COPIER>ADJUST>DENS
Subheading Contents
Level
SGNL-Y/M/C
Initial value of toner density signal (Y/M/C color)
Adjustment method
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
1
Adjustment range: 200 to 800
[Factory setting value: Factory adjustment value / Value after RAM clear: 512]