Canon imagePRESS C1 Service Manual - page 987
Chapter 16
16-90
16.4.1.2 COPIER List
0012-8316
imagePRESS C1 P
1. LASER
It is an adjustment item at the time of shipment; thus, it is not adjusted at the filed service.
T-16-88
2. IMG-REG
CS2OFWMK
Adjust the main unit offset of the solid white actual measurement brightness value K for Color
Sensor 2.
1
Setting range: 0 to 1023
Standard value: 0
CS2OFWMC
Adjust the main unit offset of the solid white actual measurement brightness value C for Color
Sensor 2.
1
Setting range: 0 to 1023
Standard value: 0
CS2OFWIK
Adjust the main unit offset of the solid white ideal brightness value K for Color Sensor 2.
1
Setting range: 0 to 1023
Standard value: 0
CS2OFWIC
Adjust the main unit offset of the solid white ideal brightness value C for Color Sensor 2.
1
Setting range: 0 to 1023
Standard value: 0
CS1OFWMM
Adjust the main unit offset of the solid white actual measurement brightness value M for Color
Sensor 1.
1
Setting range: 0 to 1023
Standard value: 0
CS1OFWIY
Adjust the main unit offset of the solid white ideal brightness value Y for Color Sensor
1
Setting range: 0 to 1023
Standard value: 0
COPIER>ADJUST>LASER
Subheading
Contents Level
PVE-OFST
Offset from the center of laser (laser exposure position)
1
Setting range: -600 to 600
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
POWER
Set the laser power when electric potential control is turned off.
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
1
Setting range: 0 to 255
[Factory setting value: Factory adjustment value / Value after RAM clear: 160]
COPIER>ADJUST>P-PASCAL
Subheading Contents
Level