Canon imagePRESS C1 Service Manual - page 1068
Chapter 16
16-171
ANIM-SW
Set whether or not to use the full-screen display for jam/alarm in MEAP application operation.
2
Although setting the value as '1' in COPIER > OPTION > BODY > MEAP-DSP, at the occurrence
of error/jam/alarm, the display transits to the standard screen for showing a warning.
When setting this value as '1', at the occurrence of error/jam/alarm,
- Display transition to the standard screen is prohibited.
- Warning is displayed on the MEAP screen to urge the user to contact servicing.
settings
0: off (display warning screen; default); 1: on (do not display warning screen)
HDD-TMP
Set a temperature for judgment of an abnormal status with low temperature in SAMSUNG HDD.
2
Setting range
0 to 30 (deg C)
Standard value
2
The setting value becomes valid after the main power switch is turned OFF/ON.
HDD-TIM
Set the grace time until it is judged as an abnormal status with low temperature in SAMSUNG
HDD.
2
Setting range
0 to 200 (minute)
Standard value
10
The setting value becomes valid after the main power switch is turned OFF/ON.
HDD-SW
Set whether or not to display the E code for an abnormal status with low temperature in
SAMSUNG HDD.
2
Setting range
0: Do not display the code.
1: Display the code.
Standard value
0
The setting value becomes valid after the main power switch is turned OFF/ON.
MEAP-SSL
Set an HTTP port for MEAP.
Set a port for the HTTP server when using SSL in the HTTP of MEAP.
2
Setting range
1 to 65535
Standard value
8443
MIX-FLG
Switch the image area flag (for image compositing).
Switch the image processing method when an image for image compositing could not be
compressed to a specified compression ratio on the main controller side.
2
Setting range
0: Image processing equivalent to the PDL character mode
1: Image processing equivalent to the PDL photo mode
2: Image processing equivalent to the SCAN character mode
3: Image processing equivalent to the SCAN photo mode
Standard value
0
KSIZE-SW
Switch the setting for the paper used in China.
Switch the setting to support the detection and display of K-size paper for the iR series scanner
and controller.
The following K-size paper is available.
8k: 270mm x 390mm / 16k: 270mm x 195mm
When this mode is set to 1 (ON) for the destination specified in MODEL-SZ= (AB group), the K-
size paper mentioned above can be detected in the document detection and recognized in the
display of the paper selection screen, etc.
2
Setting range
0: OFF: Do not support K-size paper.
1: ON: Support K-size paper.
Standard value
0: OFF
COPIER>OPTION>BODY
Subheading Contents
Level