Canon imagePRESS C1 Service Manual - page 527
Chapter 8
8-62
F-8-115
2) Detach the feeding front cover [1].
- 2 screws [2]
F-8-116
Points to Note When Attaching the Feeding Front Cover
The feeding front cover has the button to open the lower cover of the fixing/
feed unit.
To prevent the bar at the end of the button from being broken, take care to
attach the feeding front cover so that the bar is in proper position.
3) Detach the feeding upper front cover [1].
- 2 screws [2]
F-8-117
4) Remove the registration unit cable [1].
- Edge saddle [2]: 1 pc.
- Wire saddle [3]: 2 pc.
- Connector [4]: 2 pc.
F-8-118
5) Draw the registration unit cable [1] from the edge saddle [2] in the
direction of an arrow.
F-8-119
6) Remove the registration base.
- Screw [2]: 4 screws
F-8-120
8.10.7 Pre-Fixing Feeding Unit
8.10.7.1 Preparation for Removing the Pre-Fixing/
Feeding Unit
0014-1131
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you. (page 8-63)Reference [Pull-
ing/Removing the Fixing/Feeding Unit]
3) Remove the secondary transfer outer roller unit.
8.10.7.2 Removing the Pre-Fixing/Feeding Unit
0014-1132
imagePRESS C1 P / imagePRESS C1
1) Disconnect the connector [1].
2) Remove the fixing pin [2].
[1]
[2]
[1]
[2]
[1]
[2]
[1]
[2]
[3]
[4]
[1]
[2]
[1]
[2]
[3]
[4]