3Com S7902E Command Reference Manual - page 1002
1-1
1
IPv6 IS-IS Configuration Commands
IPv6 IS-IS Configuration Commands
z
The term “router” in this document refers to a router in a generic sense or a Layer 3 switch.
z
IPv6 IS-IS supports all the features of IPv4 IS-IS except that it advertises IPv6 routing information
instead. This document describes only IPv6 IS-IS exclusive commands. Refer to
IS-IS Commands
in the
IP Routing Volume
for other IS-IS configuration commands.
z
EA boards (such as LSQ1GP12EA and LSQ1TGX1EA) do not support IPv6 features.
display isis route ipv6
Syntax
display isis route ipv6
[ [
level-1
|
level-2
] |
verbose
] * [
process-id
]
View
Any view
Default Level
1: Monitor level
Parameters
verbose
: Displays detailed IPv6 IS-IS routing information.
process-id
: IS-IS process ID, in the range 1 to 65535.
level-1
: Display Level-1 IPv6 IS-IS routes only.
level-2
: Displays Level-2 IPv6 IS-IS routes only.
If no level is specified, both Level-1 and Level-2 (namely Level-1-2) routing information will be
displayed.
Description
Use the
display isis route ipv6
command to display IPv6 IS-IS routing information.