3Com S7902E Command Reference Manual - page 2085
2-13
Description
Use the
display ftp client configuration
command to display the configuration information of the FTP
client.
Currently this command displays the configured source IP address or source interface of the FTP client.
Related commands:
ftp client source
.
Examples
# Display the current configuration information of the FTP client.
The source IP address is 192.168.0.123
ftp
Syntax
ftp
[
server-address
[
service-port
] [
source
{
interface
interface-type interface-number
|
ip
source-ip-address
} ] ]
View
User view
Default Level
3: Manage level
Parameters
server-address
: IP address or host name of a remote FTP server.
service-port
: TCP port number of the remote FTP server, in the range 0 to 65535. The default value is
21.
interface
interface-type interface-number
: Specifies the source interface by its type and number. The
primary IP address configured on this interface is the source address of the transmitted packets. If no
primary IP address is configured on the source interface, the connection fails.
ip
source-ip-address:
The source IP address of the current FTP client. This source address must be the
one that has been configured on the device.
Description
Use the
ftp
command to log in to the remote FTP server and enter FTP client view.
Note that:
z
This command applies to IPv4 networks.
z
If you use this command without specifying any parameters, you will simply enter the FTP client
view without logging in to the FTP server.