3Com S7902E Command Reference Manual - page 2248
1-3
Parameters
text
: Descriptive string of a test group, in the range 1 to 200. It is case sensitive.
Description
Use the
description
command to give a brief description of a test group, usually, the test type or test
purpose of a test group.
Use the
undo description
command to remove the configured description information.
By default, no descriptive string is available for a test group.
Examples
# Configure the descriptive string for a test group as
icmp-probe
.
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] description icmp-probe
destination ip
Syntax
destination
ip ip-address
undo
destination
ip
View
DLSw, FTP, HTTP, ICMP-echo, SNMP, TCP, UDP-echo, UDP-jitter test type view
Default Level
2: System level
Parameters
ip-address
: Destination IP address of a test operation.
Description
Use the
destination ip
command to configure a destination IP address for a test operation.
Use the
undo destination ip
command to remove the configured destination IP address.
By default, no destination IP address is configured for a test operation.
Examples
# Configure the destination IP address of an ICMP-echo test operation as 10.1.1.1.
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] destination ip 10.1.1.1