3Com S7902E Command Reference Manual - page 1501
1-3
Related commands:
multicast ipv6 routing-table
in the
IPv6 Multicast Routing and Forwarding
Commands
in the
IP Multicast Volume
;
mld-snooping enable
in the
MLD Snooping Commands
in the
IP Multicast Volume
.
Examples
# Enable MLD Snooping in VLAN 100. Configure it as an IPv6 multicast VLAN and enter IPv6 multicast
VLAN view.
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 100
[Sysname-vlan100] mld-snooping enable
[Sysname-vlan100] quit
[Sysname] multicast-vlan ipv6 100
[Sysname-ipv6-mvlan-100]
port (IPv6 multicast VLAN view)
Syntax
port interface-list
undo
port
{
all
|
interface-list
}
View
IPv6 multicast VLAN view
Default Level
2: System level
Parameters
interface-list
: Specifies a port in the form of
interface-type interface-number
, or a port range in the form
of
interface-type start-interface-number
to
interface-type end-interface-number
, where the end
interface number must be greater than the start interface number.
all
: Deletes all the ports in the current IPv6 multicast VLAN.
Description
Use the
port
command to assign port(s) to the current IPv6 multicast VLAN.
Use the
undo port
command to delete port(s) from the current IPv6 multicast VLAN.
By default, an IPv6 multicast VLAN has no ports.
Note that:
z
A port can belong to only one IPv6 multicast VLAN.
z
Only the following types of interfaces can be configured as IPv6 multicast VLAN ports: Ethernet,
and Layer 2 aggregate interfaces.
Examples
# Assign ports GigabitEthernet 2/0/1 through GigabitEthernet 2/0/5 to IPv6 multicast VLAN 100.