3Com S7902E Command Reference Manual - page 1373
1-2
[Sysname] pim ipv6
[Sysname-pim6] bsr-policy 2000
c-bsr (IPv6 PIM view)
Syntax
c-bsr
ipv6-address
[
hash-length
[
priority
] ]
undo c-bsr
View
IPv6 PIM view
Default Level
2: System level
Parameters
ipv6-address
: IPv6 address of the interface that is to act as a C-BSR.
hash-length
: Hash mask length, in the range of 0 to 128. If you do not include this keyword in your
command, the corresponding global setting will be used.
priority
: Priority of the C-BSR, in the range of 0 to 255. If you do not include this keyword in your
command, the corresponding global setting will be used. A larger value means a higher priority.
Description
Use the
c-bsr
command to configure the specified interface a C-BSR.
Use the
undo c-bsr
command to remove the related C-BSR configuration.
No C-BSR is configured by default.
Note that IPv6 PIM-SM must be enabled on the interface to be configured as a C-BSR.
Related commands:
pim ipv6 sm
,
c-bsr hash-length
,
c-bsr priority
,
c-rp
.
Examples
# Configure the interface with an IPv6 address of 1101::1 as a C-BSR.
[Sysname] pim ipv6
[Sysname-pim6] c-bsr 1101::1
c-bsr hash-length (IPv6 PIM view)
Syntax
c-bsr hash-length
hash-length
undo c-bsr hash-length
View
IPv6 PIM view