3Com S7902E Command Reference Manual - page 929
1-65
View
BGP view
Default Level
2: System level
Parameters
None
Description
Use the
reflect between-clients
command to enable route reflection between clients.
Use the
undo reflect between-clients
command to disable this function.
By default, route reflection between clients is enabled.
After a route reflector is configured, it reflects the routes of a client to other clients. If the clients of a
route reflector are fully meshed, you need disable route reflection between clients to reduce routing
costs.
Related commands:
reflector cluster-id
and
peer reflect-client
.
Examples
# Disable route reflection between clients.
[Sysname] bgp 100
[Sysname-bgp] undo reflect between-clients
reflector cluster-id (BGP view)
Syntax
reflector cluster-id
{
cluster-id
|
ip-address
}
undo reflector cluster-id
View
BGP view
Default Level
2: System level
Parameters
cluster-id
: Cluster ID in the format of an integer from 1 to 4294967295.
ip-address
: Cluster ID in the format of an IPv4 address in dotted decimal notation.
Description
Use the
reflector cluster-id
command to configure the cluster ID of the route reflector.
Use the
undo reflector cluster-id
command to remove the configured cluster ID.
By default, each route reflector uses its router ID as the cluster ID.