3Com S7902E Command Reference Manual - page 97
1-14
Field
Description
Trap
State of trap messages sending. “on” indicates trap message sending is
enabled; “off” indicates trap message sending is disabled.
Log
State of log sending. “on” indicates log sending is enabled; “off” indicates
log sending is disabled.
Swi-num
Number of the forwarding state switching.
This field is numbered modulo 65,535.
duplex
Syntax
duplex
{
auto
|
full
|
half
}
undo duplex
View
Ethernet interface view
Default Level
2: System level
Parameters
auto
: Indicates that the interface is in auto-negotiation state.
full
: Indicates that the interface is in full-duplex state.
half
: Indicates that the interface is in half-duplex state. The optical interface of a Combo port does not
support the
half
keyword.
Description
Use the
duplex
command to configure the duplex mode for an Ethernet interface.
Use the
undo duplex
command to restore the duplex mode for an Ethernet interface to the default.
By default, the duplex mode for an Ethernet interface is
auto
.
Related commands:
speed
.
Examples
# Configure the interface Ethernet 2/0/1 to work in full-duplex mode.
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] duplex full
flow-control
Syntax
flow-control
undo flow-control