3Com S7902E Command Reference Manual - page 618
1-10
Field
Description
State
State of a neighbor, including:
z
INCMP: The address is being resolved. The link layer address of the
neighbor is unknown.
z
REACH: The neighbor is reachable.
z
STALE: The reachability of the neighbor is unknown. The device will
not verify the reachability any longer unless data is sent to the
neighbor.
z
DELAY: The reachability of the neighbor is unknown. The device
sends an NS message after a delay.
z
PROBE: The reachability of the neighbor is unknown. The device
sends an NS message to verify the reachability of the neighbor.
T
Type of neighbor information, including static configuration and dynamic
acquisition.
Age
For a static entry, a hyphen “-“ is displayed. For a dynamic entry, the
reachable time (in seconds) elapsed is displayed, and if it is never
reachable, “#” is displayed (for a neighbor acquired dynamically).
display ipv6 neighbors count
Syntax
display ipv6 neighbors
{
{
all | dynamic
|
static
} [
slot
slot-number
] |
interface interface-type
interface-number
|
vlan
vlan-id
}
count
View
Any view
Default Level
1: Monitor level
Parameters
all
: Displays the total number of all neighbor entries, including neighbor entries acquired dynamically
and configured statically.
dynamic
: Displays the total number of all neighbor entries acquired dynamically.
static
: Displays the total number of neighbor entries configured statically.
slot
slot-number
: Displays the total number of neighbor entries of a specified slot.
interface interface-type interface-number
: Displays the total number of neighbor entries of a specified
interface.
vlan
vlan-id
: Displays the total number of neighbor entries of a specified VLAN whose ID ranges from 1
to 4094.
Description
Use the
display ipv6 neighbors count
command to display the total number of neighbor entries
satisfying the specified condition.
Examples
# Display the total number of neighbor entries acquired dynamically.