3Com S7902E Command Reference Manual - Acl Configuration Commands
1-1
1
ACL Configuration Commands
Common Configuration Commands
display acl resource
Syntax
display acl resource
[
slot slot-id
]
View
Any view
Default Level
1: Monitor level
Parameters
slot-id
: Number of the slot.
Description
Use the
display acl resource
command to display the ACL uses on a switch.
Note that:
z
Using the command with a specified a slot will display the ACL uses of that slot. Otherwise, the
ACL uses of all slots of the device will be displayed.
z
If the board specified by the slot number is not in place or not working normally, this command will
display nothing.
Examples
# Display the ACL uses of all slots on the switch.
Interface:
Eth2/0/1 to Eth2/0/24
------------------------------------------------------------------------
Type Total Reserved Configured Remaining
------------------------------------------------------------------------
IFP ACL 1024 0 50 974
IFP Meter 512 0 44 468
IFP Counter 512 0 0 512
Interface:
Eth2/0/25 to Eth2/0/48
------------------------------------------------------------------------