3Com S7902E Command Reference Manual - page 2208
1-5
Field
Description
Port Detection Status
Power detection state of a PoE interface:
z
disabled: The PoE function is disabled.
z
searching: The PoE interface is searching for the PD.
z
delivering-power: The PoE interface is supplying
power for the PD.
z
fault: There is a fault defined in 802.3af.
z
test: The PoE interface is under test.
z
other-fault: There is a fault other than defined in
802.3af.
z
pd-disconnect: The PD is disconnected.
Port Power Mode
Power mode of a PoE interface:
z
signal: Power is supplied over signal cables.
z
spare: Power is supplied over spare cables.
Port Current Power
Current power of a PoE interface, including PD
consumption power and transmission loss
The transmission loss usually does not exceed one watt.
Port Average Power
Average power of a PoE interface
Port Peak Power
Peak power of a PoE interface
Port Max Power
Maximum power of a PoE interface
Port Current
Current of a PoE interface
Port Voltage
Voltage of a PoE interface
Port PD Description
Description of the PD connected to the PoE interface,
which is used to identify the type and location of the PD.
# Display the state of all PoE interfaces.
Interface Enable Priority CurPower Operating IEEE Detection
(W) Status class Status
GE2/0/1 enable low 4.4 on 1 delivering-power
GE2/0/2 enable critical 0 on - disabled
GE2/0/3 enable low 0 on - disabled
GE2/0/4 enable critical 0 on - searching
GE2/0/5 enable low 4.0 on 2 delivering-power
GE2/0/6 enable low 0 on - disabled
GE2/0/7 disable low 0 off - fault
GE2/0/8 disable low 0 off - disabled
GE2/0/9 disable low 0 off - disabled
GE2/0/10 disable low 0 off - disabled
GE2/0/11 disable low 0 off - disabled
GE2/0/12 disable low 0 off - disabled
--- 2 port(s) on, 8.4(W) consumed, 791.6(W) Remaining ---