3Com S7902E Command Reference Manual - page 688
1-19
display ipv6 routing-table protocol
Syntax
display ipv6 routing-table
protocol protocol
[
inactive
|
verbose
]
View
Any view
Default Level
1: Monitor level
Parameters
protocol
: Displays routes of a routing protocol, which can be
bgp4+
,
direct
,
isisv6
,
ospfv3
,
ripng
and
static
.
inactive
: Displays only inactive routes. Without the keyword, all active and inactive routes are
displayed.
verbose
: Displays both active and inactive verbose routing information. Without this keyword, only brief
active routing information is displayed.
Description
Use the
display ipv6 routing-table protocol
command to display routes of a specified routing
protocol.
Examples
# Display brief information about all direct routes.
Direct Routing Table :
Summary Count : 1
Direct Routing Table's Status :
Summary Count : 1
Destination: ::1/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Direct Routing Table's Status :
Summary Count : 0
Refer to
Table 1-6
for description about the above output.
display ipv6 routing-table statistics
Syntax
display ipv6 routing-table
statistics
View
Any view