3Com S7902E Command Reference Manual - page 924
1-60
reconnect reconnect-time:
Specifies a reconnect time, after which, the router will re-establish a
connection to the peer/peer group. It has no default value and is in the range 1 to 65535 seconds.
percentage-value
: Threshold value for the router to display an alarm message (that is, the router
displays an alarm message when the ratio of the number of received prefixes to the
prefix-number
reaches the
percentage
). It is in the range 1 to 100 and defaults to 75.
Description
Use the
peer route-limit
command to set the number of route prefixes that can be received from a
peer/peer group.
Use the
undo peer route-limit
command to restore the default.
The number is not limited by default.
Examples
# In BGP view, set the number of route prefixes that can be received from peer 129.140.6.6 to 10000.
[Sysname] bgp 109
[Sysname-bgp] peer 129.140.6.6 as-number 110
[Sysname-bgp] peer 129.140.6.6 route-limit 10000
# In BGP-VPN instance view, set the number of route prefixes that can be received from peer
129.140.6.6 to 10000 (the VPN has been created).
[Sysname] bgp 109
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-vpn1] peer 129.140.6.6 as-number 110
[Sysname-bgp-vpn1] peer 129.140.6.6 route-limit 10000
peer route-policy (BGP/BGP-VPN instance view)
Syntax
peer
{
group-name
|
ip-address
}
route-policy
route-policy-name
{
export
|
import
}
undo peer
{
group-name | ip-address
}
route-policy
route-policy-name
{
export
|
import
}
View
BGP view/BGP-VPN instance view
Default Level
2: System level
Parameters
group-name
: Name of a peer group, a string of 1 to 47 characters.
ip-address
: IP address of a peer.
route-policy-name
: Routing policy name, a string of 1 to 19 characters.
export
: Applies the routing policy to routes outgoing to the peer (or peer group).
import
: Applies the routing policy to routes incoming from the peer (or peer group).