3Com S7902E Command Reference Manual - page 2202
1-29
% Current terminal monitor is on
terminal trapping
Syntax
terminal trapping
undo terminal trapping
View
User view
Default Level
1: Monitor level
Parameters
None
Description
Use the
terminal trapping
command to enable the display of trap information on the current terminal.
Use the
undo terminal trapping
command to disable the display of trap information on the current
terminal.
By default, the display of trap information on the current terminal is enabled.
Note that:
z
The trap information is displayed (using the
terminal trapping
command) only after the monitoring
of system information is enabled on the current terminal first (using the
terminal monitor
command).
z
The configuration of this command is valid for only the current connection between the terminal and
the device. If a new connection is established, the display of trap information on the terminal
restores the default.
Examples
# Enable the display of trap information on the current terminal.
% Current terminal trapping is on