3Com S7902E Command Reference Manual - page 2250
1-5
operation-tag
: Specifies the test operation tag, a string of 1 to 32 characters. It is case-insensitive.
Description
Use the
display nqa
command to display operation information of an NQA test or tests.
If neither of the test group arguments (
admin-name
and
operation-tag
) is specified, information of all
test groups is displayed.
Examples
# Display the results of the last NQA test, in which the administrator name is
administrator
, and the
operation tag is
jitter
.
NQA entry(admin administrator, tag jitter) test results:
Destination IP address: 192.168.0.81
Send operation times: 10 Receive response times: 0
Min/Max/Average round trip time: 0/0/0
Square-Sum of round trip time: 0
Last succeeded probe time: 0-00-00 00:00:00.0
Extend results:
Packet lost in test: 100%
Failures due to timeout: 10
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
UDP-jitter results:
RTT number: 0
SD max delay: 0 DS max delay: 0
Min positive SD: 0 Min positive DS: 0
Max positive SD: 0 Max positive DS: 0
Positive SD number: 0 Positive DS number: 0
Positive SD sum: 0 Positive DS sum: 0
Positive SD average: 0 Positive DS average: 0
Positive SD square sum: 0 Positive DS square sum: 0
Min negative SD: 0 Min negative DS: 0
Max negative SD: 0 Max negative DS: 0
Negative SD number: 0 Negative DS number: 0
Negative SD sum: 0 Negative DS sum: 0
Negative SD average: 0 Negative DS average: 0
Negative SD square sum: 0 Negative DS square sum: 0
SD lost packet(s): 0 DS lost packet(s): 0
Lost packet(s) for unknown reason: 10
Table 1-1 display nqa result
command output description
Field
Description
Destination IP address
IP address of the destination
Send operation times
Number of probe packets sent