3Com S7902E Command Reference Manual - page 1047
1-32
Description
Use the
peer default-route-advertise
command to advertise a default route to a peer/peer group.
Use the
undo peer default-route-advertise
command to disable advertising a default route.
By default, no default route is advertised to a peer/peer group.
Using this command does not require the default route available in the routing table. With this command
used, the router sends the default route unconditionally to the peer/peer group with the next hop being
itself.
Examples
# Advertise a default route to peer 1:2::3:4.
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 default-route-advertise
peer description (IPv6 address family view)
Syntax
peer
{
ipv6-group-name
|
ipv6-address
}
description
description-text
undo peer
{
ipv6-group-name
|
ipv6-address
}
description
View
IPv6 address family view
Default Level
2: System level
Parameters
ipv6-group-name
: Name of a peer group, a string of 1 to 47 characters.
ipv6-address
: IPv6 address of a peer.
description-text
: Description information for the peer/peer group, a string of 1 to 79 characters.
Description
Use the
peer description
command to configure the description information for a peer/peer group.
Use the
undo peer description
command to remove the description information of a peer/peer group.
By default, no description information is configured for a peer (group).
You need create a peer/peer group before configuring a description for it.
Examples
# Configure the description for the peer group
test
as
ISP1
.
[Sysname] bgp 100 [Sysname-bgp] ipv6-family [Sysname-bgp-af-ipv6] group test external