3Com S7902E Command Reference Manual - page 1357
1-18
Default Level
2: System level
Parameters
interval
: Startup query interval in seconds, namely, the interval between general queries the MLD
querier sends on startup, with an effective range of 1 to 18000.
Description
Use the
mld startup-query-interval
command to configure the startup query interval on the current
interface.
Use the
undo mld startup-query-interval
command to restore the system default.
By default, the startup query interval is 1/4 of the MLD query interval.
By default, the MLD query interval is 125 seconds, so the startup query interval = 125 / 4 = 31.25
(seconds).
Related commands:
startup-query-interval
,
mld timer query
.
Examples
# Set the startup query interval to 5 seconds on VLAN-interface 100.
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld startup-query-interval 5
mld static-group
Syntax
mld static-group ipv6-group-address
[
source ipv6-source-address
]
undo mld static-group
{
all
|
ipv6-group-address
[
source ipv6-source-address
] }
View
Interface view
Default Level
2: System level
Parameters
all
: Removes all static IPv6 multicast groups that the current interface has joined.
ipv6-group-address
: IPv6 multicast group address, in the range of FFxy::/16 (excluding FFx0::/16,
FFx1::/16, FFx2::/16, and FF0y::), where x and y represent any hexadecimal number ranging from 0 to
F. .