3Com S7902E Command Reference Manual - page 186
1-23
Default level
2: System level
Parameters
None
Description
Use the
lldp notification remote-change enable
command to enable trap for a port or all the ports in a
port group.
Use the
undo lldp notification remote-change enable
command to restore the default.
By default, trap is disabled on a port.
Examples
# Enable trap for GigabitEthernet2/0/3.
[Sysname] interface gigabitethernet2/0/3
[Sysname-GigabitEthernet2/0/3] lldp notification remote-change enable
lldp timer notification-interval
Syntax
lldp timer notification-interval value
undo lldp timer notification-interval
View
System view
Default level
2: System level
Parameters
value
: Interval to send trap messages, in the range 5 to 3600 (in seconds).
Description
Use the
lldp timer notification-interval
command to set the interval to send trap messages.
Use the
undo lldp timer notification-interval
command to restore the default.
By default, the interval to send trap messages is 5 seconds.
Examples
# Set the interval to send trap messages to 8 seconds.
[Sysname] lldp timer notification-interval 8