3Com S7902E Command Reference Manual - page 440
1-29
The device priority is involved in spanning tree calculation. The device priority is set on a per-MSTI
basis. An MSTP-enabled device can have different priorities in different MSTIs.
If you do not provide
instance
instance-id
, your configuration will take effect in the CIST instance only.
Examples
# Set the device priority in MSTI 1 to 4096.
[Sysname] stp instance 1 priority 4096
stp region-configuration
Syntax
stp region-configuration
undo stp region-configuration
View
System view
Default Level
2: System level
Parameters
None
Description
Use the
stp region-configuration
command to enter MST region view.
Use the
undo stp region-configuration
command to restore the default MST region configurations.
By default, the default settings are used for all the three MST region parameters. Namely, the device’s
MST region name is the device’s MAC address, all VLANs are mapped to the CIST, and the MSTP
revision level is 0.
After you enter MST region view, you can configure the parameters related to the MST region, including
the region name, VLAN-to-MSTI mappings and revision level.
Examples
# Enter MST region view.
[Sysname] stp region-configuration
[Sysname-mst-region]
stp root primary
Syntax
stp
[
instance instance-id
]
root primary
undo stp
[
instance instance-id
]
root