3Com S7902E Command Reference Manual - page 838
1-39
Description
Use the
isis cost
command to set the IS-IS cost of an interface.
Use the
undo isis cost
command to restore the default.
No cost is configured by default.
If neither
level-1
nor
level-2
is included, the cost applies to both
level-1
and
level-2
.
You are recommended to configure a proper IS-IS cost for each interface to guarantee correct route
calculation.
Relate command:
circuit-cost
.
Examples
# Configure the Level-2 IS-IS cost as 5 for VLAN-interface10.
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis cost 5 level-2
isis dis-name
Syntax
isis dis-name
symbolic-name
undo isis dis-name
View
Interface view
Default Level
2: System level
Parameters
symbolic-name
: Specifies a DIS name, a string of 1 to 64 characters.
Description
Use the
isis dis-name
command to configure a name for a DIS to represent the pseudo node on a
broadcast network.
Use the
undo isis dis-name
command to remove the configuration.
No name is configured for the DIS by default.
Note that this command takes effect only on a router that must have dynamic system ID to host name
mapping enabled. This command is not supported on a Point-to-Point interface.
This command is not available in loopback interface view.