3Com S7902E Command Reference Manual - page 373
2-35
View
ONU port view
Default Level
2: System level
Parameters
uni-number
: UNI number in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
Description
Use the
uni multicast-strip-tag enable
command to configure the specified UNI to remove the VLAN
tag of the downlink multicast flow.
Use the
undo
uni multicast-group-number enable
command to remove the configuration.
By default, a UNI does not remove the VLAN tag of the downlink multicast flow.
Examples
# Remove the VLAN tag of the downlink multicast flow on UNI 1 of the ONU.
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] uni 1 multicast-strip-tag enable
uni port-isolate
Syntax
uni
uni-number port-isolate
undo uni
uni-number port-isolate
View
ONU port view
Default Level
2: System level
Parameters
uni-number
: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
Description
Use the
uni
port-isolate
command to add a UNI to an isolation group.
Use the
undo
uni
port-isolate
command to remove a UNI from an isolation group.
Only one isolation group can be created on an ONU device.
By default, a UNI is not in any isolation group.