3Com S7902E Command Reference Manual - page 1077
1-7
Parameters
preference
: BGP local preference, in the range 0 to 4294967295.
Description
Use the
apply local-preference
command to set the specified local preference for BGP routes.
Use the
undo apply local-preference
command to remove the clause configuration.
No local preference is set for BGP routing information by default.
Related commands:
route-policy
.
Examples
# Configure node 10 in permit mode of route policy
policy1
: If a route matches AS-PATH list 1, set a
local preference of 130 for the route.
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
[Sysname-route-policy] apply local-preference 130
apply mpls-label
Syntax
apply mpls-label
undo apply mpls-label
View
Route policy view
Default Level
2: System level
Parameters
None
Description
Use the
apply mpls-label
command to set MPLS labels for routing information.
Use the
undo apply mpls-label
command to remove the clause configuration.
No MPLS label is set for routing information by default.
If MPLS labels failed to apply, the routing information can not be advertised.
Examples
# Configure node 10 in permit mode of route policy
policy1
: If routing information matches AS-PATH list
1, set MPLS labels for it.
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
[Sysname-route-policy] apply mpls-label