3Com S7902E Command Reference Manual - Ntp Configuration Commands
1-1
1
NTP Configuration Commands
NTP Configuration Commands
display ntp-service sessions
Syntax
display ntp-service sessions
[
verbose
]
View
Any view
Default Level
1: Monitor level
Parameters
verbose
: Displays the detailed information of all NTP sessions.
Description
Use the
display ntp-service sessions
command to view the information of all NTP sessions. Without
the
verbose
keyword, this command will display only the brief information of all NTP service sessions.
Examples
# View the brief information of NTP service sessions.
source reference stra reach poll now offset delay disper
************************************************************************
[12345]1.1.1.1 127.127.1.0 3 377 64 178 0.0 40.1 22.8
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Total associations : 1
Table 1-1
display ntp-service sessions command output description
Field
Description
source
IP address of the clock source
reference
Reference clock ID of the clock source
1) If the reference clock is the local clock, the value of this field is
related to the value of the
stra
field:
z
When the value of the
stra
field is 0 or 1, this field will be “LOCL”;
z
When the
stra
field has another value, this filed will be the IP
address of the local clock.
2) If the reference clock is the clock of another device on the network,
the value of this field will be the IP address of that device.
stra
Stratum level of the clock source