3Com S7902E Command Reference Manual - page 1410
1-39
Description
Use the
pim ipv6 triggered-hello-delay
command to configure the maximum delay between hello
messages.
Use the
undo pim ipv6 triggered-hello-delay
command to restore the system default.
By default, the maximum delay between hello messages is 5 seconds.
Examples
# Set the maximum delay between hello messages to 3 seconds on VLAN-interface 100.
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 trigged-hello-delay 3
probe-interval (IPv6 PIM view)
Syntax
probe-interval
interval
undo probe-interval
View
IPv6 PIM view
Default Level
2: System level
Parameters
interval
: Register probe time in seconds, with an effective range of 1 to 1799.
Description
Use the
probe-interval
command to configure the register probe time.
Use the
undo probe-interval
command to restore the system default.
By default, the register probe time is 5 seconds.
Related commands:
register-suppression-timeout
.
Examples
# Set the register probe time to 6 seconds.
[Sysname] pim ipv6
[Sysname-pim6] probe-interval 6
register-policy (IPv6 PIM view)
Syntax
register-policy
acl6-number
undo register-policy