3Com S7902E Command Reference Manual - page 2276
1-31
nqa server udp-echo
Syntax
nqa server udp-echo
ip-address port-number
undo nqa server udp-echo
ip-address port-number
View
System view
Default Level
2: System level
Parameters
ip-address
: IP address specified for the UDP listening service on the NQA server.
port-number
: Port number specified for the UDP listening service on the NQA server, in the range 1 to
50000.
Description
Use the
nqa-server udp-echo
command to create a UDP listening service on the NQA server.
Use the
undo nqa-server udp-echo
command to remove the UDP listening service created.
Note that:
z
You need to configure the command on the NQA server for UDP-jitter and UDP-echo tests only.
z
The IP address and port number must be consistent with those configured on the NQA client and
must be different from those of an existing listening service.
z
The IP address must be that of an interface on the NQA server. Otherwise, the configuration will be
invalid.
Related commands:
nqa server enable
.
Examples
# Create a UDP listening service by using the IP address 169.254.10.2 and port 9000.
[Sysname] nqa server udp-echo 169.254.10.2 9000