3Com S7902E Command Reference Manual - page 692
1-23
Parameters
None
Description
Use the
display ipv6 relay-tunnel
command to display IPv6 recursive tunnel information.
Examples
# Display IPv6 recursive tunnel information.
Total Number of relay-tunnel is: 1.
Dest/Mask: 192::0/64
Related instance id(always 0): 0(1)
Table 1-10 display ipv6 relay-tunnel
command output description
Field
Description
Total Number of Relay-tunnel
Total number of recursive tunnels
Dest/Mask Destination
address/mask of the recursive tunnel
Related instance id(always 0)
IPv6 supports public networks only. Therefore, the instance
ID can be 0 only.
The number in the parentheses after the instance ID
indicates the number of routes that have used the recursive
route in the routing table.
display router id
Syntax
display router id
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the
display router id
command to display the router ID.
Examples
# Display the router ID.
Configured router ID is 1.1.1.1