3Com S7902E Command Reference Manual - page 1350
1-11
Default Level
2: System level
Parameters
None
Description
Use the
mld
command to enter MLD view.
Use the
undo mld
command to remove the configurations made in MLD view.
Note that this command can take effect only after IPv6 multicast routing is enabled on the device.
Related commands:
mld enable
;
multicast ipv6 routing-enable
in
IPv6 Multicast Routing and
Forwarding Commands
in the
IP Multicast Volume.
Examples
# Enable IPv6 multicast routing and enter MLD view.
[Sysname] multicast ipv6 routing-enable
[Sysname] mld
[Sysname-mld]
mld enable
Syntax
mld enable
undo mld enable
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the
mld enable
command to enable MLD on the current interface.
Use the
undo
mld enable
command to disable MLD on the current interface.
By default, MLD is disabled on the current interface.
Note that:
z
This command can take effect only after IPv6 multicast routing is enabled on the device.
z
Other MLD configurations performed on the interface can take effect only after MLD is enabled on
the interface.
Related commands:
mld
;
multicast ipv6 routing-table
in
IPv6 Multicast Routing and Forwarding
Commands
in the
IP Multicast Volume
.