3Com S7902E Command Reference Manual - page 128
1-8
Field
Description
Aggregation Interface
Name of the aggregate interface
Aggregation Mode
Type of the aggregation group: Static for static
aggregation, and Dynamic for dynamic
aggregation.
System ID
Local system ID
Local:
Port Status Priority Oper-Key Flag
Other information of the local end, including the
member ports, port state, port LACP priority,
operational key, and LACP protocol state flags.
Remote:
Actor Partner Priority Oper-Key SystemID Flag
Detailed information about the remote end,
including the corresponding local port, port ID,
port LACP priority, operational key, system ID,
and LACP protocol state flags
enable snmp trap updown
Syntax
enable snmp trap updown
undo enable snmp trap updown
View
Layer-2 aggregate interface view
Default Level
2: System level
Parameters
None
Description
Use the
enable snmp trap updown
command to enable linkUp/linkDown trap generation for the
current aggregate interface.
Use the
undo enable snmp trap updown
command to disable linkUp/linkDown trap generation for the
current aggregate interface.
By default, linkUp/linkDown trap generation is enabled for an aggregate interface.
Note that for an aggregate interface to generate linkUp/linkDown traps when its link state changes, you
must also enable linkUp/linkDown trap generation globally with the
snmp-agent trap enable
[
standard
[
linkdown
|
linkup
] * ] command.
Refer to
SNMP Commands
in the
System Volume
for information about the
snmp-agent trap enable
command.
Examples
# Enable linkUp/linkDown trap generation on interface
Bridge-aggregation 1
.
[Sysname] snmp-agent trap enable