3Com S7902E Command Reference Manual - page 258
1-6
Use the
undo
qos apply policy
command to remove the policy applied on a port or a port group.
In selective QinQ implementation on SC/SA/EA series boards, a QoS policy can be applied only to
incoming traffic. Therefore, the
qos apply policy
command can be applied only on ports receiving
traffic from the customer network.
For complete information about board types, refer to the accompanied installation manual.
Examples
# Apply the policy
test
in the inbound direction of GigabitEthernet 2/0/1.
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] qos apply policy test inbound
qos policy
Syntax
qos policy
policy-name
undo qos policy
policy-name
View
System view
Default Level
2: System level
Parameters
policy-name
: Policy name, a string of 1 to 31 characters.
Description
Use the
qos policy
command to create a policy. This command also leads you to policy view.
Use the
undo
qos policy
command to remove a policy.
To remove a policy that has been applied on a port, remove it from the port first.
Related commands:
classifier behavior
,
qos apply policy
.
Examples
# Create the policy
user1
.
[Sysname] qos policy user1
[Sysname-qospolicy-user1]