3Com S7902E Command Reference Manual - page 2194
1-21
# Set the output channel for the log information of VLAN module to
snmpagent
and to output
information with severity being
emergencies
. Log information of other modules and all the other
system information cannot be output to this channel.
[Sysname] info-center source default channel snmpagent debug state off log state off trap
state off
[Sysname] info-center source vlan channel snmpagent log level emergencies state on
info-center synchronous
Syntax
info-center synchronous
undo info-center synchronous
View
System view
Default Level
2: System level
Parameters
None
Description
Use the
info-center synchronous
command to enable synchronous information output.
Use the
undo info-center synchronous
command to disable the synchronous information output.
By default, the synchronous information output is disabled.
z
If system information, such as log information, is output before you input any information under a
current command line prompt, the system will not display the command line prompt after the
system information output.
z
If system information is output when you are inputting some interactive information (non Y/N
confirmation information), then after the system information output, the system will not display the
command line prompt but your previous input in a new line.
Examples
# Enable the synchronous information output function, and then input the
display interface ethe
command to view Ethernet interface information.
[Sysname] info-center synchronous
% Info-center synchronous output is on