3Com S7902E Command Reference Manual - page 126
1-6
Field
Description
Partner ID
System ID of the partner
Select Ports
The number of selected ports
Unselect Ports
The number of unselected ports
Share Type
Load sharing type
display link-aggregation verbose
Syntax
display link-aggregation
verbose
[
bridge-aggregation
[
interface-number
] ]
View
Any view
Default Level
1: Monitor level
Parameters
bridge-aggregation
: Displays detailed information about the Layer-2 aggregate groups corresponding
to Layer-2 aggregate interfaces.
interface-number
: Aggregate interface number. The value range is 1 to 1,024. Note that the aggregate
interface you specify must already exist.
Description
Use the
display link-aggregation verbose
command to display detailed information about the
aggregation groups corresponding to the aggregate interfaces.
To display the information of a specific Layer-2 aggregate group, use the
display link-aggregation
verbose bridge-aggregation
interface-number
or
display link-aggregation
verbose
bridge-aggregation
interface-number
command.
To display the information of all Layer-2 aggregate groups, use the
display link-aggregation
verbose
bridge-aggregation
or
display link-aggregation
verbose route-aggregation
command.
To display the information of all aggregate groups, use the
display link-aggregation
verbose
command.
Examples
# Display the detailed information of the aggregation group corresponding to Layer-2 aggregate
interface
Bridge-aggregation 10
.
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,