3Com S7902E Command Reference Manual - page 2043
1-29
Use the
undo
shutdown-interval
command to restore the default.
By default, the detection interval is 30 seconds.
Note that:
z
If a protocol module such as the operation, administration and maintenance (OAM) module detects
an exception on a port (for example, signal loss of the link on the peer end), the port will be closed
automatically, without execution of the
shutdown
command. You can set the automatic recovery
time of the port by using the
shutdown-interval
command.
z
The
shutdown-interval
command helps you to dynamically set a detection interval to cooperate
with the OAM module.
z
If you change the detection interval to T1 during interface detection, the interval from when you
change the interval to the time when detection starts is T. If T be brought up after T1-T time; if T>=T1, the interface which is down will be brought up immediately. Examples # Set the detection interval to 100 seconds. [Sysname] shutdown-interval 100 strict-standby enable Syntax strict-standby enable undo strict-standby enable View System view Default Level 2: System level Parameters None Description Use the strict-standby enable command to enable active/standby mode for service ports on SRPUs. Use the undo strict-standby enable command to disable active/standby mode for service ports on SRPUs.