3Com S7902E Command Reference Manual - page 448
1-37
Parameters
packet-number
: Maximum number of MSTP packets that the port(s) can send within each hello time,
namely the maximum transmission rate of the port, in the range of 1 to 255.
Description
Use the
stp transmit-limit
command to set the maximum transmission rate of the port(s).
Use the
undo stp transmit-limit
command to restore the system default.
By default, the maximum transmission rate of all ports of the device is 10.
Note that:
z
Configured in port view, the setting takes effect on the current port only; configured in port group
view, the setting takes effect on all ports in the port group.
z
Configured in Layer-2 aggregate port view, the setting takes effect only on the aggregate port.
Configured on the member port in an aggregation group, the setting can take effect only after the
port leaves the aggregation group. For detailed information about link aggregation, refer to
Link
Aggregation Configuration
in the
Access Volume
.
z
A larger maximum transmission rate value represents more MSTP packets that the port will send
within each hello time, but this means that more device resources will be used. An appropriate
maximum transmission rate setting can prevent MSTP from using excessive bandwidth resources
during network topology changes.
Examples
# Set the maximum transmission rate of port GigabitEthernet 2/0/1 to 5.
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] stp transmit-limit 5
vlan-mapping modulo
Syntax
vlan-mapping modulo
modulo
View
MST region view
Default Level
2: System level
Parameters
modulo
: Modulo value, ranging from 1 to 31.
Description
Use the
vlan-mapping modulo
command to map VLANs in the current MST region to MSTIs
according to the specified modulo value.
By default, all VLANs are mapped to the CIST (MSTI 0).