3Com S7902E Command Reference Manual - page 1462
1-40
Default Level
2: System level
Parameters
ipv6-group-name
: Name of an IPv6 MBGP peer group, a string of 1 to 47 characters.
ipv6-address
: IPv6 address of an IPv6 MBGP peer.
Description
Use the
peer reflect-client
command to configure the router as a route reflector and specify an IPv6
MBGP peer/peer group as its client.
Use the
undo peer reflect-client
command to remove the configuration.
By default, neither route reflector nor client is configured.
Related commands:
reflect between-clients
,
reflector cluster-id
.
Examples
# Configure the local device as a route reflector and specify the peer group
test
as a client.
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test internal
[Sysname-bgp-af-ipv6] quit
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] peer test enable
[Sysname-bgp-af-ipv6-mul] peer test reflect-client
peer route-limit (IPv6 MBGP address family view)
Syntax
peer
{
ipv6-group-name
|
ipv6-address
}
route-limit
limit
[
percentage
]
undo peer
{
ipv6-group-name
|
ipv6-address
}
route-limit
View
IPv6 MBGP address family view
Default Level
2: System level
Parameters
ipv6-group-name
: Name of an IPv6 MBGP peer group, a string of 1 to 47 characters.
ipv6-address
: IPv6 address of an IPv6 MBGP peer.
limit
: Specifies the upper limit of IPv6 address prefixes that can be received from the peer or peer group,
in the range 1 to 6144.
percentage
: If the number of received routes divided by the upper limit reaches the specified
percentage, the system will generate alarm information. The percentage is in the range 1 to 100. The
default is 75.