3Com S7902E Command Reference Manual - page 2307
1-14
# Add virtual IP address 10.10.10.11 to VRRP group 1.
[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.10.10.11
VRRP Configuration Commands for IPv6
display vrrp ipv6
Syntax
display
vrrp ipv6
[
verbose
] [
interface
interface-type interface-number
[
vrid virtual-router-id
] ]
View
Any view
Default Level
1: Monitor level
Parameters
verbose:
Displays detailed state information of VRRP.
interface
interface-type interface-number
: Displays VRRP state information of the specified interface.
interface-type
interface-number
specifies an interface by its type and number.
vrid virtual-router-id
: Displays state information of the specified VRRP group.
virtual-router-id
specifies
a VRRP group by its group number, in the range 1 to 255.
Description
Use the
display
vrrp ipv6
command to display the state information of VRRP for IPv6.
If you do not specify
verbose
, only the brief state information of VRRP is displayed.
If you specify both an interface and a VRRP group, only the state information of the specified VRRP
group is displayed; if you only specify an interface, the state information of all the VRRP groups on the
interface is displayed; if you specify neither, the state information of all the VRRP groups on the device
is displayed.
Examples
# Display brief information about all VRRP groups on the device for IPv6.
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Total number of virtual routers: 1
Interface VRID State Run Adver. Auth Virtual
Pri Time Type IP
---------------------------------------------------------------------
Vlan100 1 Master 100 100 NONE FE80::1
# Display detailed information about all VRRP groups on the device.
IPv6 Standby Information:
Run Method : VIRTUAL-MAC