3Com S7902E Command Reference Manual - page 1005
1-4
If no level is specified, the default route belongs to Level-2.
Description
Use the
ipv6 default-route-advertise
command to generate a Level-1 or Level-2 IPv6 IS-IS default
route.
Use the
undo ipv6 default-route-advertise
command to disable generating a default route.
No IPv6 IS-IS default route is generated by default.
With a routing policy, you can configure IPv6 IS-IS to generate the default route that must match the
routing policy. You can use the
apply isis level-1
command in routing policy view to generate a default
route in L1 LSPs, or use the
apply isis level-2
command in routing policy view to generate a default
route in L2 LSPs, and use the
apply isis level-1-2
in routing policy view to generate a default route in
L1 and L2 LSPs respectively.
Refer to
Routing Policy Commands
in the
IP Routing Volume
for information about the
apply isis
command.
Examples
# Configure the router to generate a default route in Level-2 LSPs.
[Sysname] isis
[Sysname-isis-1] ipv6 default-route-advertise
ipv6 enable
Syntax
ipv6 enable
undo
ipv6 enable
View
IS-IS view
Default Level
2: System level
Parameters
None
Description
Use the
ipv6 enable
command to enable IPv6 for the IPv6 IS-IS process.
Use the
undo ipv6 enable
command to disable IPv6.
IPv6 is disabled by default.