3Com S7902E Command Reference Manual - page 1539
1-7
display mpls ldp Isp
Syntax
display mpls ldp lsp
[
all
| [
vpn-instance
vpn-instance-name
] [
destination-address
mask-length
] ] [
|
{
begin
|
exclude
|
include
}
regular-expression
]
View
Any view
Default Level
1: Monitor level
Parameters
all
: Specifies all LSPs established by LDP.
vpn-instance-name
: Name of the VPN instance, a case-sensitive string of 1 to 31 characters.
dest-addr
: Destination address of the LSP.
mask-length
: Length of the mask for the destination address, in the range 0 to 32.
|
: Uses a regular expression to filter the output information. For details about regular expression, refer to
Basic System Configuration
in the
System
Volume
.
begin
: Displays all lines starting with the line that matches the regular expression.
exclude
: Displays all lines other than those matching the regular expression..
include
: Displays all lines matching the regular expression.
regular-expression
: Regular expression, a case-sensitive string of 1 to 80 characters.
Description
Use the
display mpls ldp lsp
command to display information about LSPs established by LDP.
Related commands:
display mpls ldp
.
Examples
# Display information about all LSPs established by LDP.
LDP LSP Information
--------------------------------------------------------------------------
SN DestAddress/Mask In/OutLabel Next-Hop In/Out-Interface
-------------------------------------------------------------------------
1 1.1.1.1/32 3/NULL 127.0.0.1 -------/InL0
2 10.1.1.0/24 3/NULL 10.1.1.1 -------/Eth1/1
*3 100.1.1.1/32 Liberal(1025)
-------------------------------------------------------------------------- A '*' before an
LSP means the LSP is not established
A '*' before a Label means the USCB or DSCB is stale