3Com S7902E Command Reference Manual - page 1086
1-16
[Sysname-route-policy] if-match extcommunity 100 150
if-match interface
Syntax
if-match interface
{
interface-type interface-number
}&
undo if-match interface
[
interface-type interface-number
]&
View
Route policy view
Default Level
2: System level
Parameters
interface-type
: Interface type
interface-number
: Interface number
&
: Indicates the argument before it can be entered up to 16 times.
Description
Use the
if-match interface
command to specify interface(s) for matching against the outbound
interface of routing information.
Use the
undo if-match interface
command to remove the match criterion.
The match criterion is not configured by default.
Related commands:
if-match acl
,
if-match ip-prefix
,
if-match ip next-hop
,
if-match cost
,
if-match
tag
,
route-policy
,
apply ip-address next-hop
,
apply cost
,
apply local-preference
,
apply origin
,
apply tag
.
Examples
# Configure node 10 in permit mode of route policy
policy1
to permit routing information with the
outbound interface as VLAN-interface 1.
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match interface vlan-interface 1
if-match mpls-label
Syntax
if-match mpls-label
undo if-match mpls-label
View
Route policy view
Default Level
2: System level