3Com S7902E Command Reference Manual - page 2311
1-18
Default Level
1: Monitor level
Parameters
interface
interface-type interface-number
: Clears VRRP statistics of a specific interface.
interface-type
interface-number
specifies an interface by its type and number.
vrid virtual-router-id
: Clears VRRP statistics of the specified VRRP group.
virtual-router-id
specifies a
VRRP group by its group number, in the range 1 to 255.
Description
Use the
reset vrrp ipv6 statistics
command to clear VRRP statistics.
If you specify both an interface and a VRRP group, the statistics about the specified VRRP group on the
specified interface are cleared; if you specify only an interface, the statistics about all the VRRP groups
on the interface are cleared; if you specify neither, the statistics about all the VRRP groups on the
device are cleared.
Examples
# Clear the statistics about all the VRRP groups on the device.
vrrp ipv6 vrid authentication-mode
Syntax
vrrp ipv6 vrid
virtual-router-id
authentication-mode
simple
key
undo vrrp ipv6 vrid
virtual-router-id
authentication-mode
View
Interface view
Default Level
2: System level
Parameters
virtual-router-id
: VRRP group number, in the range 1 to 255.
simple
: Sets the authentication mode to plain text authentication.
key
: Authentication key of 1 to 8 case-sensitive characters in plain text.
Description
Use the
vrrp ipv6 vrid
authentication-mode
command to configure authentication mode and
authentication key for the VRRP groups to send and receive VRRP packets.
Use the
undo vrrp ipv6
vrid
authentication-mode
command to restore the default.
By default, authentication is disabled.
Note that:
z
Before executing the command, create a VRRP group on an interface and configure the virtual IP
address of the VRRP group.