3Com S7902E Command Reference Manual - page 2070
1-21
Default Level
2: System level
Parameters
file-name
: File name, whose extension name must be .cfg.
safely
: Sets the configuration saving mode to safe. If this argument is not specified, the configuration
file is saved in fast mode.
Description
Use the
save
file-name
command to save the current configuration to the specified configuration file,
but the system will not specify the file as the startup configuration file for the next system startup. If the
file specified by
file-name
does not exist, the system will create the file and then save the configuration
to the file.
Use the
save
[
safely
] command to save the current configuration to a configuration file and specify the
file as the startup configuration file for the next system startup.
Note that:
If you use the
save
file-name
command, even if the configuration file auto-save function is enabled, the
SMB does not automatically save the current configuration to its own configuration file. If you do not
specify the
file-name
argument, the SMB automatically saves the current configuration when the AMB
executes the
save
[
safely
] command.
Related commands: reset saved-configuration, display current-configuration, display
saved-configuration.
Examples
# Save the current configuration file to the default directory.
The current configuration will be written to the device.
Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/testcfg.cfg](To leave the
existing filename unchanged, press the enter key):
flash:/testcfg.cfg exists, overwrite?[Y/N]:y
Validating file. Please wait...
Now saving current configuration to the device.
Saving configuration flash:/testcfg.cfg. Please wait...
.
Configuration is saved to flash successfully.
slave auto-update config
Syntax
slave
auto-update
config
undo slave
auto-update
config